Editing Adjustable Pins aka Microfasteners
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
This page supports semantic in-text annotations (e.g. "[[Is specified as::World Heritage Site]]") to build structured and queryable content provided by Semantic MediaWiki. For a comprehensive description on how to use annotations or the #ask parser function, please have a look at the getting started, in-text annotation, or inline queries help pages.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| − | Adjustable pins, also known as Microfasteners, are a way to replace traditional pins on a razor. The material required can be obtained from [http://www.microfasteners.com/ Microfasteners]. The original article was posted by [ | + | Adjustable pins, also known as Microfasteners, are a way to replace traditional pins on a razor. The material required can be obtained from [http://www.microfasteners.com/ Microfasteners]. The original article was posted by [http://straightrazorpalace.com/members/philadelph.html Philadelph].<ref>http://straightrazorpalace.com/workshop/15896-requested-adjustable-pins.html</ref> |
== Required Material == | == Required Material == | ||
| Line 13: | Line 13: | ||
== 3/4" screws == | == 3/4" screws == | ||
| − | I did get the 3/4" screws, just in case. Also a lot easier to get everything threaded if you are replacing only the pivot pin. I used the washers as thrust washers, and the filigree is from a bead shop-- you flatten with smooth pliers, and drill the hole out to 1/16.<ref> | + | I did get the 3/4" screws, just in case. Also a lot easier to get everything threaded if you are replacing only the pivot pin. I used the washers as thrust washers, and the filigree is from a bead shop-- you flatten with smooth pliers, and drill the hole out to 1/16.<ref>http://straightrazorpalace.com/workshop/15896-requested-adjustable-pins.html#post153414</ref> |
<gallery caption="3/4'' screws" widths="180px" heights="160px" perrow="2"> | <gallery caption="3/4'' screws" widths="180px" heights="160px" perrow="2"> | ||
| Line 24: | Line 24: | ||
: ''Main article: [[Illustrated Guide to Sleeving an Oversized Pivot]]'' | : ''Main article: [[Illustrated Guide to Sleeving an Oversized Pivot]]'' | ||
| − | If the pin hole of the razor should be too wide, filling it with epoxy and then drilling through the epoxy might help.<ref> | + | If the pin hole of the razor should be too wide, filling it with epoxy and then drilling through the epoxy might help.<ref>http://straightrazorpalace.com/workshop/15896-requested-adjustable-pins-2.html#post237888</ref> |
[[Image:Microfasteners Fotoguru Epoxy in pin-hole.jpg|center|400px]] | [[Image:Microfasteners Fotoguru Epoxy in pin-hole.jpg|center|400px]] | ||
